@beerwright/core
    Preparing search index...

    Interface DecoctionPull

    One sized decoction.

    interface DecoctionPull {
        achievedTempC: number;
        awayMinutes: number;
        currentTempC: number;
        evaporationL: number;
        explain: Explanation;
        fractionOfMash: number;
        heatCapacityLEquivalent: number;
        issues: readonly DecoctionIssue[];
        mashAfter: MashAfterDecoction;
        pullGrainKg: number;
        pullVolumeL: number;
        pullWaterL: number;
        ratioLPerKg: number;
        restTempAtReturnC: number;
        returnTempC: number;
        stepIndex: number;
    }
    Index
    achievedTempC awayMinutes currentTempC evaporationL explain fractionOfMash heatCapacityLEquivalent issues mashAfter pullGrainKg pullVolumeL pullWaterL ratioLPerKg restTempAtReturnC returnTempC stepIndex
    achievedTempC: number

    Where the mash actually lands, °C.

    Equal to the target for a pull this module sized. It differs when the brewer set DecoctionSpec.pullVolumeL to fit their own pot, which is why it's reported.

    awayMinutes: number

    How long the pull is out of the tun, minutes — rest + ramp + boil + return.

    currentTempC: number

    Temperature the mash was resting at when the pull was taken, °C.

    Reported because restTempAtReturnC only makes sense next to it. The difference is the drift, which is zero on a rig that heats the mash while it rests. A caller that shows only one of them can't tell a tun that cooled from one that held temperature.

    evaporationL: number

    Water the boil evaporates, litres.

    explain: Explanation

    The breakdown behind pullVolumeL.

    fractionOfMash: number

    The pull as a fraction of the mash, by heat capacity, 0–1.

    heatCapacityLEquivalent: number

    The pull's heat capacity, water-equivalent litres — w + c·g.

    issues: readonly DecoctionIssue[]

    Problems with this pull.

    mashAfter: MashAfterDecoction

    The mash the next step starts from.

    pullGrainKg: number

    Grain in the pull, kilograms. Zero for a thin pull.

    pullVolumeL: number

    What the pot reads once the pull is in it, litres.

    pullWaterL: number

    Liquid in the pull, litres.

    ratioLPerKg: number

    Water per kilogram of grain in the pull after clamping, litres per kilogram.

    restTempAtReturnC: number

    What the resting mash has drifted to by the time the pull returns, °C.

    returnTempC: number

    Temperature the pull returns at, °C.

    stepIndex: number

    Index of the rest this pull reaches, into DecoctionPlanInput.steps.

    Settings
    Member Visibility

    On This Page
    Properties